How To Install Wood Siding Corners
If more than one clapboard is needed to span a wall snap a chalk line between the marks on the corner boards on top of the course being overlapped.
How to install wood siding corners. You should be able to wiggle the siding slightly. Vertical corner boards are generally installed before the wood siding so that the siding butts snugly against its edge. Hammer the first nail into the nailing slot. Measure all corners from where the wall meets the roof to the bottom of the corner strip with a tape measure and.
Slide the ends under the corner posts in the same manner. The siding is fitted against door and window casings in the same way. Staple a layer of house wrap to the sheathing working from the bottom up and overlapping joints by several inches so that any water that reaches it will shed down the wall. Option a if you have chosen not to use epoxy you may now fasten the wood rain screen corners with 1 1 4 stainless steel screws through the back of the plywood.
Plywood sheathing provides a sound flat base for lap siding. Clamp your wood outside corner pieces to the plywood corner assembly. Nail the clapboard to the studs. Install your starter sheet.
Carefully slide the notched piece of siding into place. Each corner should be hung straight so drop a plumb line for each corner post. Now you are ready to predrill the back of the wood corner. How to install corner boards for clapboard siding 1.
Divide the length of each wall by 8 inches the width of a piece of siding. Be sure to nail all nails at the top of the slots so that the posts hang from the nails. Again follow the manufacturer s recommendations. If the result is a whole number you re in.
Put a level starter strip around the house at the bottom of the wall as a starting point for clapboard and to mark. If corner boards are not used the siding boards of adjacent walls extend to meet in a mitered joint at the corner. Slide the bottom of the siding into the footer being sure to allow for expansion. Join the clapboards with scarf joints as in step 3.