Howmtomlower One Side Of Sierra Rv Awning

Rotate this leg clockwise as many times as you did the front leg.

Howmtomlower one side of sierra rv awning. Pull the awning strap to one side and tie it to an arm to keep it out of the way. This technique works whether the awning is open or rolled up. Make sure to keep the arms parallel to one another so you don t damage the unit. Set one side of the awning lower than the other if it rains this will allow the water to run off instead of collecting on top of the awning.

You should now be at the rear of the awning facing the front. Slide the rafters down to the rest position. Grasp the awning to prevent it from rolling up by itself. Lower the rear leg detach it from the rv and prop it up on the ladder like we did for the front leg in the previous steps.

If necessary use a screwdriver or other tool to pry open the awning extrusion track on one side. Next do the same to the other side of the awning. So reattach the front leg to the side of the rv and raise it up a bit. Once you have your awning installed you might need to make sure that the slope is the right angle and the extension is appropriate.

Flip the control lever on the right side of the roller tube as though you were preparing to fully extend the awning. Rv adhesive tape release a sticky awning ratchet lever by releasing the awning lever with one hand while pulling down gently on the awning support arm with your other hand. Adjusting your retractable awning is not as difficult as it may seem. Loosen the rafters knobs and release the rafter catches.

Step 1 undo the travel latch or lock that holds the awning to the side of the rv. Have two people hold the awning against the side of the rv and slowly walk it down while a third person feeds the fabric into the rail track. There is one at each end of the awning. If you have a standard spring loaded awning with small black rafter knobs loosen the knobs now just a few turns are necessary don t remove them or loosen them all the way.

Lower the awning arms to the rest position. When done pop the lower ends of both awning arms out from their brackets on the side of the rv and extend them until they are both touching the ground.