How To Install Metal Roofing On Steep Roof

Following adequate safety procedures including those.

How to install metal roofing on steep roof. Work up from the initial row starting at the lower corner in a diagonal pattern staggering the shingles to prevent gaps. The eave flashing or edging is just the steel metal strips used to cover the entire perimeter of the roof. Working on any roof is dangerous and slick metal roofs with a steep pitch are particularly perilous. If playback doesn t begin shortly try restarting your device.

Next you are ready to install the metal roof. Install shingles from the lower left corner working to the right and also working up the roof slope. How to apply roofing to a steep roof. You are essentially sealing off the metal roof with this flashing and you need to make sure that is securely fastened.

Arrange the shingles so the ends and the tab notches do not lie directly above gaps in the shingle below. For exposed fasteners avoid over tightening the fastener. If the gaps lined up water could get directly onto the roof sheathing and then seep in through a nail hole. To watch the entire series from the beginning click here.

Tips for working on steep metal roofs. Lay the starter row of metal shingles at the drip edge and affix to the roof with metal roofing nails. Use your neoprene washer head screws to secure the metal to the sheathing. Most metal shingles will be attached to the roof using metal shingle.