How To Safely Lift A Sheet Of Glass From Table
Check the suction grip of the pad.
How to safely lift a sheet of glass from table. Wrap it in a sheet use hammer rock large book etc to break up and then bundle the old sheet into the trash can. Wrap it like a russian nesting doll. To begin wrap the glass table topin at least two overlapping layers of bubble wrap. Tightly tape the wrap so that it does not shift around the glass.
If it seems loose release the suction on the pad and reattach it as needed. Heavy plastic bags would probably work well. Area of glass m2. With the bubble wrap secure wrap the entire table top with the moving blankets once again at least two layers deep.
Place each suction pad flush against the surface and work the lever to establish proper suction. Exactly what i was going to suggest. Others are screwed in. Place the glass down flat on the ground and cover the entire pane with an old blanket or several old towels to keep the shards in place before using a hammer or shovel to break the pane.
Do not carry it over your head or under your arms. Two to lift two to receive. If the path from the truck to the window is smooth use a glass dolly. Some table tops simply lift off the bottom of the table or piece.
Single sheets of glass may not seem like much of a hazard but when several sheets are stacked together their combined weight can be enough to cause serious. Safety ware such as gloves along with glass lifters are recommended for manual handling. If the piece is small say 6 square the weight pulling on the glass is pretty small in comparison with it s size. Hold the glass firmly in your hands.
Look to see how the top is attached and then use a screwdriver or other hand tool to carefully remove the glass. If the piece is expensive hire a furniture moving service recommends john linden the lead designer at mirror coop a glass studio. Always wear gloves with rubber coated palms. If the glass is heavy use a suction cup for your lower hand.
Clean and dry the surface of the glass. Use your upper hand without a cup as a guide hand to maintain balance. When setting glass on the floor or other any other surface gently place it down on the long edge. Do not let any surface bump or hit the glass edges or corners.