How To Replace An Awning Motor

This will give you room to work.

How to replace an awning motor. Purchase a replacement awning fabric. Remove the cap spring. Use high quality heavyweight tight weave vinyl for the best results. Install the motor by sliding it all the way into the end of the roller tube.

If you thought replacing your rv s main patio awning was out of your league as a do it yourselfer watch this first and you just might change your mind. Replacing the motor on a solara power awning extend your awning about 2 feet. We used the old awning as our work space to prevent scuffing or damage to the new awning. Reinstall the gear for the manual handle.

Client on a budget. Tie the awning arms off to the bracket where it attaches to the side of your rv. The steps to replace the rv awning are almost the opposite of the removal. Install a new motor and tighten the bolts.

Unbolt the chain from the drive shaft of the awning motor. Refer to the owner s manual as the parts included can be slightly different from manufacture to manufacturer. If this is the case unplug the motor from the electrical source. We then secured the polly cord with screws to the roller.

Afterward head to a home hardware store and purchase an appropriately sized replacement fabric. Do this on both ends. Loosen the awning bolts. Loosen the bolts holding it in place and lift it out of the housing.

New motor and wind sensor. We carefully unfolded located front and back and slid the new rv awning with the attached polly cord into the awning roller. Start by measuring your awning from the inside of each cap. Choose a fabric replacement.

Measure for the correct awning replacement fabric. How to replace rv awning fabric. To do so measure from the center of one arm to the.