How To Remove Vinyl Siding And Vinyl Trim

Slide the vinyl siding removal tool just under the bottom lip of the uppermost piece of vinyl siding and pry gently upwards.

How to remove vinyl siding and vinyl trim. If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in. Remove the vinyl panel directly above the trim at the top of the garage door. Slip the curved end of a vinyl siding zip tool into the seam between two horizontally interlocking runs of siding that you need to remove. If it remains stuck double check to see if.

Hook the zip tool into the notch at one end of the vinyl panel. If the siding is hard to remove try tapping it with the palm of your hand. Start by lifting an overlapped piece of vinyl on the top row. Once the snap seal releases use gloved fingers to loosen the siding to a distance of 3 feet from the corner.

Repeat until you re at the ground and then remove the surrounding trim. This discussion has moved to a new article now. Remove the nails one at a time to disconnect the entire length of vinyl. Slide the tool along the bottom of the vinyl panel to detach it from the starter strip above the.

There we show how to use this vinyl siding hook or siding removal tool to un hook vinyl siding to permit repair replacement or other work. You might need to wiggle the tool to work it into the. You should be able to slide it horizontally and remove it from the channel to expose the nails from the second row down. At vinyl siding hook to remove replace.

Vinyl siding is installed from the bottom up so you must loosen it in the opposite direction.