How To Put Up An Awning On A Trailer

You can use your hands to pull the strap the rest of the way until the awning is fully extended.

How to put up an awning on a trailer. Learn how to operate your trailer awning or rv awning with the step by step instructions in this 5 minute video. Now use the awning rod to pull the roller tube out about 1 foot 0 30 m from the rv. Use the rod to pull the strap straight out opening the awning. Once the railing is completely secured go ahead and unroll your new awning by pulling on the awning tube down and toward you until the awning is fully unrolled.

Roll the awning out 1 foot 0 30 m from the rv. Rv slide out awning installation is a relatively simple process that requires two sets of hands and about an hour of your time and this small addition will work wonders in keeping debris such as sticks and leaves off of the top of your awning which has been known to damage the top seal of your sidewall cut out and cause potentially major. Slide the end of the valance section s cord into the channel you marked with a v or other indicator. Step 2 with a helper hold the extrusion rail against the rv in the location of your choice.

Roll out the awning using the awning rod. Start by flipping the control lever on the right side of the roller tube as though you re preparing to fully extend the awning. Slide the upper awning arms in place and then while holding the awning taut with one hand adjust the tension arm using the tension knobs on each side. Hook the black pull strap on the awning with your awning rod.

The article linked below also includes a a downloadable step by step instruction sheet that you may want to print laminate and store in your trailer or rv. Slide the end of the main section s cord into the channel you marked with an m or other indicator. The butyl tape will help keep out moisture and prevent leaks.