How To Nail Tongue And Groove Siding
A variety of siding types fit together by means of tongues and grooves or over and underlapping edges.
How to nail tongue and groove siding. Common gauges for nails used in tongue and groove installation include 15 16 17 and 18. If the siding is up to 6 inches wide it can be nailed with one siding nail per bearing but siding any wider should use two nails per bearing. If you can t pull them out carefully pry the board away from the building paper beneath and cut the nails from the underside with a small hacksaw. When blind nailing the nail is sent into the groove at roughly a 45 degree angle.
As such it s possible to use 15 gauge nails with lengths of 1 inch 1 5 inches or 2 inches. The next grooved edge will hide the nail holes. Drive the nails through the shoulder of the tongues into the framing at about a 45 degree angle. One of the cool things about tongue and groove walls is that you can use a technique called blind nailing if you do it properly you won t have any nail heads showing or holes to fill.
In horizontal application start at the bottom and work up with the groove edges facing downwards. Tongue groove installation tongue and groove siding can be installed horizontally or vertically. With tongue and groove paneling the nails are inserted into the groove and hammered to below the surface. The gauge of a nail has nothing to do with its length.
The paneling will be nailed directly to these furring strips. As the gauge of a nail increases the nail is smaller. Use a nail puller to yank out the nails that anchor the boards to be removed. Tongue and groove siding tool list.
On the side of the building the roof angle was three pitch so we knew we had to cut our tongue and groove cedar boards at a 15. To install tongue and groove paneling vertically begin by nailing 1 by 3 furring strips horizontally either directly to the wall studs on a new wall or over the drywall on a finished wall. Tongue and groove or lapped sidings generally have a rustic cabinlike appearance. Because the nail goes in at an angle and needs to be sunk a nail gun is a better option than a hammer.
To ensure that the nail gets into the groove where it will be hidden it must be inserted at an angle. Nails should penetrate 1 1 4 inch into solid wood behind the siding. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue. The tongue section of the board should be at the top with the groove section at the bottom.
Nail up the first panel at a corner of the room with the tongue side facing out. The nail can be started with a normal carpenter s hammer and then made flush with the surface of the groove by means of a nail set. This is part 1 of a 3 part series.