How To Nail A Tarp To A Roof

Screw the 2 by 4 directly into the roof to secure it.

How to nail a tarp to a roof. Sandwich the tarp by nailing a second 2 x 4 board to. Unfold the tarp on the roof. Don t forget to secure the strapping used in step 4. Positions several 1 2 pieces of lumber on the tarp running vertically down the slope of the roof.

Create an anchor board by rolling the tarp s peak end with a 2 x 4 inch board and nailing the tarp to your board with. Nail the tarp to the fascia board over the edge of the roof or along the ridge. Make sure the screw goes through the tarp then the wooden board and into the roof. Screw through the tarp and the boards into the roof with a drill.

When you can t reach it and the roof is dry and sturdy climb onto the roof until you can reach the edge of the tarp and wrap it around the plank. Wrap the other edge of the tarp around the plank. Next on the peak side attach the tarp to the 2 by 4 using cap nails. Installing tarp on a roof without nails 1.

Measure the dimensions of the tarp to be used. Find the source of the leak. Partially unroll your tarp to cover the damaged area from the roof s eaves to peak. Screw the roll side down either at the edge of the roof or to the fascia with a few screws pulling the tarp tight around the edges apply 1 3 strapping with deck screws every 8 to 12 making sure you have one within 2 to 3 of each edge.

Roll the tarp over the damaged area taking care that it extends at least 3 on all sides. It probably goes without saying but the size of the damage also. Then with a drill screw in 2 inches 5 1 cm long screws. Pull the tarp tight and smooth out wrinkles.

Climb on top of the. To secure a tarp to your roof. Time to add your furring strips. There should be an additional 4 feet.

You need to know first which spot on the roof needs tarping up. Stretch a tarp flat on the roof. If you have it cover the nail heads with roofing cement to keep it watertight. Install a blue tarp on a roof.

Then fold the excess tarp under a few rotations for a tight clean fit. If you have a helper this part is easy. Choose 6 equally spaced spots on each 2x4 board. Try to pick a day that is not windy or else you may face frustration.

Place the plywood or sheet metal over the hole and use roofing nails and a hammer or decking screws and a cordless drill to secure the plywood to the roof. The 2 by 4 should be about 2 feet longer than the tarp width. Find the source of the roof leak.