How To Install Starter Roofing

Place the cover over the vent opening and screw into place.

How to install starter roofing. First snap a line for the top of the. If possible have the shingles delivered via a boom directly onto the roof. Apply a second layer of sealant around the lip of the vent outside. Install a starter strip.

After the first shingle has been placed on the roof set the second starter shingle next to it. Butt the edges together instead of overlapping them. Before peeling the shingle starter strip trim about 4 inches off an end of the first starter strip and align the strip to the area you are planning to stick it on. Finally nail the first course of shingles directly on top of and flush with the starter course.

Overlap each row at least 3 to 4 inches. Typically the finish shingles are then installed to align with the edge of the starters. Whether installed at the eave or the rake the starter shingles should overhang the edge of the roof by inch to inch. Do not penetrate the shingles with the hammer.

Using your staple gun secure the felt to the roof. Then move into the attic and apply to the underside of the opening and vent. Where do the nails go. Install new flashing metal.

How to do it prep work space. The adhesive on the starter course seals the tabs of the first full course. Using four roofing nails or up to six in high wind areas secure the starter shingle to the surface of the roof. Drill starter holes if needed then scew down the vent with the fasteners in the installation kit.

Detailed installation of starter strip shingles at the valleys and hips. Gaf pro series starter strip shingles valley hip install. Quick installation tips for how to install gaf starter strip shingles on a roof. Use four roofing nails per shingle as indicated on package instructions six nails in high wind areas.

Start by laying asphalt felt or other underlayment over the roof. You will want the roof granular side up when applying the strip. Continuing with the starter shingles.